Proceedings of the American Electric Railway AssociationAmerican Electric Railway Association, 1920 |
Edisi yang lain - Lihat semua
Istilah dan frasa umum
adopted as standard American Electric Railway American Railway Association approved boilers burner cable cent Chairman Circular mils Committee on Equipment Committee on Standards Committee recommends conductor consideration contract Contractor cost CURVED HEAD RAILS demand diameter dielectric strength dimensions duct Electric Railway Engineering Engineering Manual ensuing Committee Farkell FLANGE CONTOUR frogs fuel furnace furnished Gage GAUGING POINTS gear girder rails grooved grooved rails guard rails H. H. ADAMS inch inspection joint journal bearing Journal Boxes lag screws length less limit of wear manhole manufacturers material matter minimum mittee motor obtained operating PLAIN END SPIRAL Plain girder point rails Power Company present PRESIDENT HILL pulverized coal rail heads railroads Railway Company Railway Engineering Association recom Recommended Specification revision special trackwork Standards Committee steam steel wheels stoker stranded SWITCH EASEMENT switch rods thickness tion TRACK SPIRALS TREAD AND FLANGE Versine wire
Bagian yang populer
Halaman 185 - The materials should be mixed wet enough to produce a concrete of such a consistency as will flow into the forms and about the metal reinforcement, and which, at the same time, can be conveyed from the mixer to the forms without separation of the coarse aggregate from the mortar.
Halaman 370 - The purchaser may make the tests to govern the acceptance or rejection of the material in his own laboratory or elsewhere. Such tests, however, shall be made at the expense of the purchaser.
Halaman 179 - Contractor's Liability Insurance. — The Contractor shall maintain such insurance as will protect him from claims under workmen's compensation acts and from any other claims for damages for personal injury, including death, which may arise from operations under this Contract, whether such operations be by himself or by any subcontractor or anyone directly or indirectly employed by either of them.
Halaman 174 - IN WITNESS WHEREOF, the said parties have caused these Presents to be properly executed on 'behalf of each; dated the day and year first above written. (Party of the first part) COMPANY, By President. ATTEST : Secretary. (Party of the second part) COMPANY, By President.
Halaman 208 - ... tests upon two additional samples shall be made, and the average of the three tests shall determine acceptance or rejection of the coil. For wire whose nominal diameter is between listed sizes, the requirements shall be those of the next larger size included in Table I.
Halaman 170 - Engineer, nor assert that there was any misunderstanding in regard to the nature or amount of work to be done.
Halaman 177 - The inspection of the work shall not relieve the contractor of any of his obligations to fulfill his contract as herein prescribed, and defective work shall be made good, and unsuitable materials may be rejected, notwithstanding that such work and materials have been previously overlooked by the Engineer and accepted or estimated for payment If the work, or any part thereof, shall be found defective before the final acceptance of the whole work, the contractor shall forthwith make good such defect,...
Halaman 360 - An analysis to determine the percentages of carbon, manganese, phosphorus and sulphur shall be made by the manufacturer from a test ingot taken during the pouring of each melt, a copy of which shall be given to the purchaser or his representative.
Halaman 173 - All work that may be called for in the specifications and not shown on the plans, or shown on the plans and not called for in the specifications, shall be executed and furnished by the Contractor as if described in both these ways; and should any work or material be required which is not denoted...
Halaman 180 - Contractor shall be entitled to the full amount of the estimate for the work done by him under this contract up to the time of such annulment, including the retained percentage. The Contractor shall be reimbursed by the Company for such expenditures as in the judgment of the Chief Engineer...