Pocket Companion for Engineers, Architects and Builders, Containgin Useful Information and Tables Appertaining to the Use of Steel, Manufactured by Carnagie Steel Company, Pittsburgh, PaCarnegie Steel Company, 1913 - 400 halaman |
Edisi yang lain - Lihat semua
Pocket Companion for Engineers, Architects and Builders, Containgin Useful ... Carnegie Steel Company Pratinjau tidak tersedia - 2016 |
Istilah dan frasa umum
60 radii Allowable Fiber Stress ALLOWABLE UNIFORM LOAD AMERICAN BRIDGE COMPANY arch Area Axis of moments bars bending moment Bolts BRIDGE COMPANY STANDARD buckling Carnegie Steel Company cent Circular Segment column compression concrete CORRUGATED Decimal Fractional Decimal Fractional Decimal dimensions distance Flange Angles Flange Width Fractional Decimal Fractional horizontal lines inch in thickness inch rivets Inches Inches Inches Pounds Inches Thickness Inches Web Thickness Inches Weight Inches3 lines will produce live load LOADS IN THOUSANDS material Maximum Bending Stress Moment of Inertia ness neutral axis Plates 14 Plates 35 lb POUNDS Allowable Fiber pounds for lengths pounds per square radius of gyration ratios of 1/r rods rolled Safe load values Section Index Depth section modulus shear shearing stress slab square foot square inch Stress per square tensile THOUSANDS OF POUNDS tie rods unit stresses Weight per Foot x 1½ x 6 x zigzag line
Bagian yang populer
Halaman 48 - The inspector representing the purchaser shall have free entry, at all times while work on the contract of the purchaser is being performed, to all parts of the manufacturer's works which concern the manufacture of the material ordered. The manufacturer shall afford the inspector, free of cost, all reasonable facilities to satisfy him that the material is being furnished in accordance with these specifications. All tests...
Halaman 47 - The object of this test is to open and render visible to the eye any seams due to failure to weld up or to interposed foreign matter, or any cavities due to gas bubbles in the ingot.
Halaman 36 - ... in. in thickness, around a pin the diameter of which is equal to twice the thickness of the specimen.
Halaman 29 - Material which, subsequent to the above tests at the mills, and its acceptance there, develops weak spots, brittleness, cracks, or other imperfections, or is found to have injurious defects, will be rejected at the shop and shall be replaced by the manufacturer at his own cost.
Halaman 5 - The test specimen, when heated to a bright cherry red, shall bend through 180 deg. flat on itself without fracture on the outside of the bent portion. (c) Nick-bend Tests.
Halaman 150 - The pitch of rivets at the ends of built compression members shall not exceed four diameters of the rivets for a length equal to 1^ times the maximum width of the member. (d) Two-Angle Members. In tension members composed of two angles, a pitch of 3'-6...
Halaman 20 - To determine whether the material conforms to the requirements specified in Section 4, an analysis shall be made by the manufacturer from a test ingot taken during the pouring of each melt.
Halaman 41 - ... in thickness, around a pin the diameter of which is equal to the thickness of the specimen; and for material over 1^4 in.
Halaman 27 - ... in. or more in thickness, one tension and one bend test shall be made from both the thickest and the thinnest material rolled. (b) If any test specimen shows defective machining or develops flaws, it may be discarded and another specimen substituted.
Halaman 51 - All tests and inspection shall be made at the place of manufacture prior to shipment, and shall be so conducted as not to interfere unnecessarily with the operation of the works.