Bulletin, Volume 19,Bagian 1American Society for Testing and Materials., 1919 Vols. 1-61 include reports of the 1st-64th annual meetings, committee reports and technical papers; v.16-38 include also "New and revised tentative standards [and] tentative revisions of standards" (varies slightly) |
Edisi yang lain - Lihat semua
Istilah dan frasa umum
22 GAGE LOW-COPPER A.S.T.M. Standards accepted for publication Actual Freezing Treatments Alloys aluminum American Society annual meeting antimony Assistant Secretary Association for Testing Babbitt Metal bars bricks calcined Carbon cent Chairman Clay coat Committee A-1 Compressive Strength Concrete Copper determined Doctor Marburg Edgar Marburg Engineering Council Executive Committee flash point forge welding Fort Sheridan GAGE LOW-COPPER PURE grade Group gypsum plaster ingots Inland Steel Co inspection lath letter ballot vote lime Manganese Manganese Bronze manufacturer membership metal mittee molds Number Open-hearth Steel paint Paint Thinners Phosphorus picnometer plates present proposed Tentative Specifications Rating REPORT OF COMMITTEE represent requirements sample sand Series sheets Society for Testing sodium-sulfate test Sodium-Sulfate Treatments solution specific gravity specified in Section Standard Specifications Standards Committee Sub-Committee submitted on behalf Sulfur surface Table temperature tensile strength Tentative Methods tentative standard test specimen Testing Materials thickness tion weight wire
Bagian yang populer
Halaman 460 - The inspector representing the purchaser shall have free entry, at all times while work on the contract of the purchaser is being performed, to all parts of the manufacturer's works which concern the manufacture of the material ordered.
Halaman 448 - Gage Length for Elongation Note: — The gage length, parallel section, and fillets shall be as shown, but the ends may be of any shape to fit the holders of the testing machine in such a way that the load shall be axial.
Halaman 406 - ... (b) If any test specimen shows defective machining or develops flaws, it may be discarded and another specimen substituted. (c) If the percentage of elongation of any tension test specimen is less than that specified in Section 5 (a) and any part of the fracture is more than f in.
Halaman 421 - ... works which concern the manufacture of the material ordered. The manufacturer shall afford the inspector, free of cost, all reasonable facilities to satisfy him that the material is being furnished in accordance with these specifications. All tests (except check analyses) and inspection shall be made at the place of manufacture prior to shipment, unless otherwise specified, and shall be so conducted as not to interfere unnecessarily with the operation of the works.
Halaman 405 - ... or to interposed foreign matter, or any cavities due to gas bubbles in the ingot. One side of each fracture shall be examined and the lengths of the seams and cavities determined, a pocket lens being used if necessary.
Halaman 425 - Rehearing. represent rejected material, shall be preserved for two weeks from the date of the test report. In case of dissatisfaction with the results of the tests, the manufacturer may make claim for a rehearing within that time.
Halaman 404 - For material 1 in. or under in thickness, around a pin the diameter of which is equal to the thickness of the specimen; and for material over 1 in.
Halaman 572 - ... cc must be added dropwise with particular care to" allow each drop to be fully decolorized before the next is introduced.
Halaman 641 - The rate of rise of temperature shall be uniform and shall not be averaged over the period of the test.
Halaman 606 - This term shall be applied to the finely pulverized product resulting from the calcination of an argillaceous limestone at a temperature only sufficient to drive off the carbonic acid gas.